High Temperature Resistant Centrifugal Pump Installer
Nouveaux produits
  • pompe auto-amorçante fzb
    pompe auto-amorçante en plastique fluoré fzb

    La pompe auto-amorçante en plastique fluoré fzb est conforme aux normes internationales. Les pièces de débordement sont en plastique fluoré. Les pièces porteuses sont constituées de matériaux métalliques. Elles peuvent être équipées d’un joint externe pour machine, d’un joint externe pour machine d'assemblage et d'eau de rinçage. personnalisé.

    Lire la suite
  • pompe centrifuge en acier inoxydable
    ih pompe centrifuge à un étage d'eau de mer en acier inoxydable

    la pompe centrifuge à eau salée à un étage en acier inoxydable ih en acier inoxydable peut être en acier inoxydable 304.316.316l et super double phase. C’est une excellente pompe de transfert et de déchargement pour le transport de diverses concentrations d’eau de mer, d’eau salée et de solvants organiques.

    Lire la suite
dernières nouvelles
Pompe centrifuge à connexion directe doublée de téflon ihf-d

Pompe centrifuge à connexion directe doublée de téflon ihf-d

La pompe centrifuge doublée de fluor ihf-d est un produit amélioré de la pompe centrifuge doublée de fluor ihf. ce qui est plus résistant aux acides q

IH stainless steel chemical centrifugal pump

2023/07/04

IH stainless steel single-stage single-suction seawater salt water centrifugal pump


IH stainless steel chemical centrifugal pump using mechanical seal points for attention:


  • 1. As the mechanical seal is generally suitable for use in clean, non-suspended particle media, the newly installed pipeline system and liquid storage tank should be washed carefully to prevent solid impurities from entering the end face of the mechanical seal and make the seal invalid.
  • 2. In a medium that is easy to crystallize, frequent flushing should be paid to the use of mechanical seals. Clean the crystals on the mechanical seal before restarting after stopping.
  • 3. Disassemble the mechanical seal carefully, do not knock with hand hammer, hammer, etc., so as not to destroy the moving ring, static ring seal and so on.
  • 4. If there is dirt that can not be removed, try to remove the dirt, rinse thoroughly and then disassemble it, so as not to damage the sealing element.
  • 5. Before installing the mechanical seal, all sealing elements should be checked for failure or damage, and if so, they should be repaired or replaced.
  • 6. The relative friction sealing surface of the moving ring and the static ring should be strictly inspected, and any minor scratches, bruises and other defects are not allowed. All other parts, including pump body, impeller, sealing cavity, etc., should be washed before assembly, especially the moving ring and static ring should be cleaned with clean, soft cloth or cotton yarn, and then coated with a layer of clean grease or oil.
  • 7. attention should be paid to eliminating deviation in assembly and tightening screws evenly to avoid deflection and seal failure.
  • 8, correctly adjust the compression amount of the spring, after the pump is installed, when moving the rotor with a handboard, it should feel that the sealing spring not only has a certain amount of compression, but also can rotate flexibly without the feeling of bite. If it feels too tight or the disk does not move, it should be loosened properly.
  • 9. For the mechanical seal with external flushing, the flushing fluid should be opened before starting, so that the sealing cavity is filled with sealing fluid. When stopping, stop the pump first, and then turn off the sealing washing fluid.




   

l\'équipe professionnelle au service !